What does it mean when your electronic throttle control light comes on?
Solution: This indicates a serious failure of your throttle control system. The engine computer is programmed to go into limp mode when the system malfunctions, in an attempt to limit your speed and prevent damage to the engine. It can be caused by a sensor failure, or even by outside electromagnetic interference.
What are the symptoms of a bad electronic throttle control?
Rather than moving a cable, ETC uses sensors to inform the ECM of the position of the gas pedal, and when it fails, symptoms can be severe. Some of these include sudden idle surges and engine stalling, an engine light that flashes intermittently, or a massive drop in mileage.
How do you reset the electronic throttle control system on a Dodge Caliber?
To reset the system all You need to do is turn on the vehicle without starting the engine. After that You can just press down on the throttle pedal for ten seconds and wait until the engine light starts to blink. When that happens it is resetting the throttle body and the ECU’s memory.
How much does it cost to fix electronic throttle control?
Since this is such a key part to every car’s internal system, the average cost for this repair can be quite pricey – the average electronic throttle control repair cost comes out to around $645!
How do I calibrate my electronic throttle body?
Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds.
How to reset Dodge Caliber electonic throttle contro?
The idle air control valve reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and… Hi there. The alarm should not affect the use of the key to unlock and lock the driver’s door. The linkage from the door lock cylinder to the door latch assembly must be disconnected.
How does the electronic throttle control work on a Dodge?
Electronic throttle control. With the key in the on position, but car is not running just all the lights on on the panel, gently push the accelerator pedal to the floor, should take about 20-30 seconds, hold it there for 30 seconds then gently release it all the way out taking another 30 seconds.
What causes high idling in Dodge Caliber electonic?
Hi there. Generally speaking, a high idling engine is caused by a failure of the idle control valve or a vacuum leak. It’s also possible that the throttle body is damaged. You might want to have a professional mechanic come…
What are the problems with the Dodge Caliber?
See all problems of the 2007 Dodge Caliber . When braking the electric throttle control light flashes momentarily. It does not stay on. The car does not brake completely at these times and continues to accelerate and move forward another foot or two despite pressing the brake.
