Are Lawn Genie and Irritrol valves the same?
The DPR series are the same valves as the Lawn Genie model L701 & L703. The Irritrol APR model is a good choice for a residential system where a anti-siphon valve is appropriate (see below). These anti-siphon valves have a built in atmospheric backflow preventer.
How do you know if an irrigation valve is bad?
Signs of issues in sprinkler valve:
- Water not turning Off: If you notice that water is not closing off from the sprinkler, then there seems to be an issue in the diaphragm valve.
- Leaks of water:
- Broken Sprinkler Head.
- Stuck Valve.
- Wiring:
- Irregular Watering:
What happens when sprinkler valve goes bad?
Too much water, and you can have waterlogged sections of the lawn. Not only does this make walking on these sections of lawn uncomfortable, but it can also lead to a deterioration in the health of that patch. Too little water due to a bad sprinkler valve can lead to dry and unsightly brown patches on your lawn.
How do you clean a lawn genie sprinkler valve?
- Unscrew the top of the valve, and remove the diaphragm.
- Turn on the water supply, and flush the system for 15 seconds. Examine the diaphragm for defects.
- Remove the solenoid, and clean any debris or obstructions from its ports. Reassemble the valve, and turn on the water.
How does Lawn Genie valve work?
The Lawn Genie L7034 Anti-Siphon Valve is equipped with a flow-control screw so you can easily adjust the rate the sprinklers emit water. The flow-control screw adjusts the amount of water pressure that goes to the sprinkler zone serviced by the valve.
Is Toro and Irritrol the same?
The company’s products are marketed under several brands: Toro – irrigation systems & supplies, professional and consumer mowers, compact utility equipment, snow blowers, and handheld trimmers and leaf blowers. Irritrol Systems – irrigation systems for residential and commercial landscapes. Lawn-Boy – consumer mowers.
How long should sprinkler valves last?
Valves will give you 10 to 15 years of service, while controllers 5 to 10 years.
How often should sprinkler valves be replaced?
How much does it cost to replace a sprinkler valve?
The cost to replace a sprinkler valve runs about $12.50 to $40 each for most models, plus labor expenses. The valve controls the release of water to the various zones in the yard.
What causes a sprinkler valve to stay on?
Air Trapped in the Valve: The valves may have air trapped in them. A small bubble of air becomes trapped in the tiny water ports of the valve, this stops the water from flowing through the port. Since the water flowing through the port is what holds the valve diaphragm closed, the valve stays open.
How do you get dirt out of a sprinkler valve?
Unscrew the nozzle of the sprinkler and pull out the filter to see if it’s dirty. Running the filter under cold water will remove any dirt. Flushing a sprinkler line will remove dirt and other debris. Automatic sprinkler systems rely on clean pipes and steady water pressure to operate properly.
Do you need a Lawn Genie valve repair kit?
Additionally, the kit prevents homeowners from having to replace the entire valve. The kit contains parts for both angle and anti-siphon manual valves, along with stem assemblies and o-rings for both 3/4 in. and 1 in. valves and anti-siphon manual valves. The replacement parts are compatible with Models 706LG, 709LG, L3010, L3034, L4010, and L4034.
What’s the replacement solenoid for a Lawn Genie?
The replacement solenoid for valve model 54003 is L10000 and the diaphragm is model 54006. The kit did not fit my application and does come with 2 valves and 2 o rings. I just ended up replacing the old with a different valve purchased at Home Depot. Good luck and not a difficult job.
How do you change the flow control on a Lawn Genie?
Screw the solenoid into the new valve. Turn the flow control screw knob, the large screw knob on the top of the valve, clockwise until it stops to close the valve. Turn the water and power on. Turn the manual bleed screw, the smaller screw located to the side of the flow knob, counterclockwise to allow water through the valve.
Is the Lawn Genie valve adapter part number l32100?
No, it does not. Lawn Genie Valve model L7034 uses diaphragm model number L13100. No, it does not. The repair kit for L4034 is part number L32100. Does this kit work on a 3/4″ Lawn Genie/Richdel #R623 valve actuator?
