How do you clean a Ford IAC?
Clean and Install the IAC Valve
- Clean the valve intake ports and the throttle-mounting surface and mating ports using carburetor cleaner.
- Wipe the valve ports clean with a swab and the throttle mating ports with a clean shop towel or rag.
- Set the clean IAC valve in place along with a new valve gasket if equipped.
Can I clean my IAC?
How do you clean an IAC valve? After relocating the IAC valve, you need to unscrew it and detach all the wires. You can clean it by soaking it in gasoline and blowing compressed air into it. Then, reattach it with the screws and reconnect the wires.
How do you unclog a IAC valve?
Hold the valve pointed downward, and spray the pointed end of the valve with carburetor cleaner, and wipe it clean. (Don’t allow the carburetor cleaner to drip into the housing.) Repeat until all the carbon is removed.
How to clean idle air control on a Ford Ranger?
While holding it so that the motor is pointed up and the ports are at the bottom, spray it out with a good carburetor or throttle body cleaner. Be careful not to get any cleaner in the motor portion of it. Make sure that the gasket is still good, and re-install the IAC. If the gasket is damaged, you can get a new one from the parts store.
How do you clean the IAC valve on a Ford F150?
Whether installing the old valve or swapping in a new unit, clean the throttle body mating surface of all old gasket material. Position the valve in place with a new gasket and install the 8mm bolts as well as washers. Torque the bolts to approximately 7.5 ft/lbs. Reconnect the electrical harness to the IAC valve.
How can I clean my idle air control?
Some people remove their IAC and clean it. It’s not difficult to do. Unplug the IAC. Remove the (2) bolts with a 10mm socket.. While holding it so that the motor is pointed up and the ports are at the bottom, spray it out with a good carburetor or throttle body cleaner.
How do you remove IAC valve on Triton engine?
(On the 5.4L Triton engines, it is easier to remove the valve itself before disconnecting the electrical plug.) Remove the (2) 8mm bolts securing the IAC valve in place. Be sure to collect the washers and gasket during removal.
