How do I reset my Huebsch dryer?
Programming Your Speed Queen / Huebsch Dryer Computers
- Start with all the DIP switches in the two blocks under the display in the OFF position (down)
- Press reset button to clear memory.
- Press button to the left of the display to show start time for the dryer.
How do you change a belt on a Huebsch dryer?
How do you change a belt on a Huebsch dryer?
- Shut off the power. Unplug the dryer.
- Raise the cabinet top.
- Remove the front panel.
- Remove the drive belt.
- Install the new drive belt.
- Reinstall the front panel.
- Reassemble the top panel.
- Restore power to the dryer.
Is Huebsch the same as Speed Queen?
For the most part if you buy a Huebsch washer or a Speed Queen washer your getting the same machine. You might have some cosmetic differences between them but the guts are the same.
What does sh mean on Unimac dryer?
dead short errors
SH errors are dead short errors, so the first thing to do is go to the back of the commercial dryer and check the temperature sensing probe. A likely problem is that the dryer’s thermistor needs to be replaced, so simply change that part and check to see if the SH error is gone.
Why is my Coinamatic card not working?
It means that you are not using a valid smart card. Ensure that you use the correct card and that it is inserted properly. If your card still doesn’t work, contact the Customer Care at 1-800-561-1972.
How long does a Huebsch washer take?
approximately 26 minutes
A cycle takes approximately 26 minutes.
How do you reset a Unimac washing machine?
Once the bearings have been lubricated, reset the bearing counter by pressing and holding the STOP, BACK and LCD buttons. Press the arrow buttons until Reset Bearing Timer is highlighted and press ENTER. The counter will reset and the text will change to Bearing Timer Reset.
What does e fl mean on a washer?
E:dr – Drain Error – Maximum drain time exceeded or water is still being detected at end of spin cycle. E:FL – Fill Error – Pressure switch fails to open in 30 minutes in any fill agitate cycle.
How to troubleshoot a Huebsch commercial dryer?
Huebsch commercial dryer troubleshooting will help you in this. For dryers equipped with a power cord, make sure the power cord is plugged all the way into the electrical outlet. Make sure loading door is closed. Push timer knob in to start dryer.
Who is the customer service team for Huebsch?
Huebsch has a team of experienced Alliance Laundry Systems Customer Service For Huebsch Dryer Maintenance. Download Huebsch Washer Manual Pdf Now!
What to do if Huebsch error code persists?
Check coin drop area and remove obstructions. If error persists, tampering may have occurred. Evaluate security procedures. Re-aim external device and try again. External device is improperly aimed at infrared communicator (angle or distance).
What to do when Huebsch says replace control?
Replace control. External device is improperly aimed at infrared communicator (angle or distance). Re-aim external device and try again. External device is improperly aimed at infrared communicator (angle or distance). Re-aim external device and try again. External device removed before communication complete.
